Trango Systems, Inc. GigaPlus User Manual Rev 3.1 193
sync_state is used to display the current synchronization status
between Active and Standby unit.
The following parameters will not be synchronized.
Alarm, alignment, cableloss, fanctrl, ibm, ipconfig, license key,
loopback mode, opmode, tftpd and traps
sysinfo
sysinfo <0-6>
Default: N/A
Configuration Storage: No
sysinfo without any parameter will display the current IDU and ODU
configuration parameters.
sysinfo takes a parameter for information category: 0=version info,
1=Management, 2=Radio Config, 3= System Config , 4=Ethernet
5=ACM, 6=threshold settings
sysinfo is a system-level command.
View the current configuration status of the local side IDU and ODU.
To select a subset of the entire system info, add the argument 0
through 6 after the sysinfo command
To Next Page
Loading...