Trango Systems TrangoLINK GigaPlus - Utype_Switch

Trango Systems, Inc. GigaPlus User Manual Rev 3.1 202
Failover Counter: # of times the units have switched roles from active
to standby and vice-a-versa
Election Period: yes (during election period), no (not in election
period)
Debug Reg: For debugging
EXAMPLE
(CLI-config)# utype
Current utype: active
Protection: off
Redundancy Cable: connected
Remote Unit Status: standby detected
Sync Status: Synchronized
Guard Time: 15 seconds
Failover Counter: 0
Election Period: no
Debug Reg: (D6)0x00, (D5)0x00, (24)0x1F
utype_switch
SYNTAX
utype_switch
Default: N/A
Configuration Storage: N/A
utype_switch does not take any input parameter. Will perform utype
switch from Active to Standby.
This command only allowed on the Active unit. Can NOT be initiated
on Standby unit
DESCRIPTION
utype_switch manually switch the Active to the Standby unit by
sending Switchover REQ to the standby unit.
This command is mainly used for image upgrades. During the image
upgrades, the standby unit can upgrade first and when done, perform