Trango Systems TrangoLINK GigaPlus - Page 130

Trango Systems, Inc. GigaPlus User Manual Rev 3.1 130
(CLI-config)# status port
<====================== Ethernet Counters ======================>
Port: ge1 ge2 ge3 ge4 nternal
Enable: on on on on on
Status: off off off off on
Duplex: full full full full full
Speed: 1000 1000 1000 1000 1000
In Octets: 362607 4535496 0 0 2698731294
In Ucast Pkt: 4444 2617317006 0 0 2323868109
In NUcast Pkt: 136 0 0 0 1
Out Octets: 922671622 1719593480 0 0 3076730927
Out Ucast Pkt: 14415821 2308569723 0 0 652052464
Out NUcast Pkt: 1 135 0 0 136
CRC Errors: 0 0 0 0 20
CollisionError: 0 0 0 0 0
<======================== RF Counters ==========================>
IN OUT
Total Octets: 4280834626 3284730808
Total Pkt: 2328890117 653833881
Total Drop Pkt: 20 N/A
Port Rate(Mbps): 0 0
Port Util(%): 0 0
Run the status clear command
After the link has been established and the Ethernet interfaces are running properly, the
counters may all be cleared. This is typically done just prior to the link validation phase
in which a fixed amount of traffic or packets are passed over the link over a period of
time to ensure no drops occur. The status clear command will clear all port counters
and the BER counters.
(CLI-config)# status clear
Run the syslog clear command