Trango Systems, Inc. GigaPlus User Manual Rev 3.1 132
IP Enable
Trap 1: 0.0.0.0 off
Trap 2: 0.0.0.0 off
Trap 3: 0.0.0.0 off
Trap 4: 0.0.0.0 off
Trap 5: 0.0.0.0 off
Set the trap 1 manager IP address using the trap ip command – repeat for additional
trap manager ip addresses:
(CLI-config)# trap ip 1 10.14.1.5
IP Enable
Trap 1: 10.14.1.5 off
SUCCESS
Enable the trap number 1 using the trap enable 1 on on command – The trap will be
enabled and the status shown:
CLI-config)# trap enable 1 on
IP Enable
Trap 1: 10.14.1.5 on
To Next Page
Loading...