Trango Systems TrangoLINK GigaPlus - Page 6

Trango Systems, Inc. GigaPlus User Manual Rev 3.1 6
CLI Common Task Reference ...............................................................................................125
Setting up the In-Band-Management (IBM) ...............................................................125
Capacity License Activation .............................................................................................128
Automatic Transmit Power Control (ATPC) Configuration (optional) ...............128
Check Ethernet and RF port Statistics .........................................................................129
Enable Traps (Optional).....................................................................................................131
8.0 Troubleshooting ........................................................................ 133
Symptom: No Link (Lock = 0 during linktest) ....................................................................133
MSE is too high and/or bit errors are showing when running linktest .....................133
Receive Signal Level is too low .............................................................................................134
RF Link is good but packet loss is occurring: ...................................................................135
No direct management using Out of band port ...............................................................135
No Radio Management connection over the link ............................................................136
T1/E1 Ports not passing traffic ...............................................................................................136
Appendix A – Command Line Interface Reference ......................... 137
Command Keying Overview ...................................................................................................137
Key Functions ........................................................................................................................137
Different Node Levels ................................................................................................................138
View Node ...............................................................................................................................138
Config Node............................................................................................................................140
Debug Node ...........................................................................................................................145
Individual Command Details ...................................................................................................146
acm ............................................................................................................................................146
alarm .........................................................................................................................................147
atpc ............................................................................................................................................148
ber ..............................................................................................................................................149
bootimage ................................................................................................................................149
cableloss ..................................................................................................................................150
config .........................................................................................................................................151
custom_profile .......................................................................................................................153
datapath ...................................................................................................................................153
datapattern ..............................................................................................................................154
date ............................................................................................................................................155
debug ........................................................................................................................................155
default_opmode ....................................................................................................................156
diagnostics ..............................................................................................................................157
egress_margin .......................................................................................................................157
eth_info .....................................................................................................................................158
failover ......................................................................................................................................159