Configure Management Access
Security > Management Access > Management Service
This section allows the configuration of ports to require authorization/authentication,
guest VLAN assignment for unauthenticated users, and authentication methods
required on network access ports.
1. Log into your switch management page (see “Access your switch management page”
on page 11).
2. Click on Security, click on Management Access, and click on Management Service.
3. Review the settings. Click Apply to save the settings.
Management Service
• Telnet: Enables Telnet command line management access to the switch.
• SSH: Enables SSH command line management access to the switch.
• HTTP: Enables HTTP web management access to the switch. By default, HTTP
management access is enabled.
• HTTPS: Enables HTTPS web management access to the switch.
• SNMP: Enables SNMP management access to the switch.
• Session Timeout: Configure the idle timeout settings to automatically log out of
the specified management session during times of inactivity. Enter the 0 value
to disable automatic logout.
• Console: Enables Telnet command line management access to the switch.
SSH: Enables SSH command
• Password Retry Count: Configure the number of failed attempts allowed for
the specified management access before access is locked for the period
specified under Silent Time.
• Silent Time: Configure the silent time period defining amount of time the
management access prevents logins after the max. password retry count is
reached.