Technical Specifications
TPE-3012LS
Standards
• IEEE 802.1d
• IEEE 802.1p
• IEEE 802.1Q
• IEEE 802.1s
• IEEE 802.1w
• IEEE 802.1X
• IEEE 802.1ab
• IEEE 802.3
• IEEE 802.3u
• IEEE 802.3x
• IEEE 802.3z
• IEEE 802.3ab
• IEEE 802.3ad
• IEEE 802.3af
• IEEE 802.3at
• IEEE 802.3az
Device Interface
• 8 x Gigabit PoE+ ports
• 2 x Gigabit ports
• 2 x 100/1000Mbps SFP slots
• LED indicators
• 4-Digit PoE LED display (total power budget, available power, consumption
per port)
Data Transfer Rate
• Ethernet: 10Mbps (half duplex), 20Mbps (full duplex)
• Fast Ethernet: 100Mbps (half duplex), 200Mbps (full duplex)
• Gigabit Ethernet: 2000Mbps (full duplex)
Performance
• Switch fabric: 24Gbps
• RAM buffer: 512KB
• MAC address table: 8K entries
• Jumbo frames: 10KB
• Forwarding mode: store and forward
• Forwarding rate: 17.8Mpps (64-byte packet size)
Management
• HTTP / HTTPS web-based GUI – Standard or Surveillance Mode
• CLI command line interface (Telnet / SSHv2)
• SNMP v1, v2c, v3
• IPv4/IPv6 support
• Multiple user accounts
• Dynamic/static unicast MAC address table
• Enable or disable 802.3az power saving per port
• Syslog
• System message logging severity levels
• Port mirroring (transmit, receive, one-to-one, many-to-one)
• ICMPv4/ICMPv6
• Traceroute
• LLDP
• Cable diagnostics test
• SFP DDM (Digital-diagnostic-monitoring)
• UDLD (UniDirectional Link Detection)
• Port error disabled/Errdisable state
• Ping watchdog
MIB
• RMON MIB RFC 1271
• IPV4 MIB RFC 1213 (read only)
• SNMP MIB RFC 3415
To Next Page
Loading...
