TRENDnet TPE-3012LS - Configure ACL Port Binding

© Copyright 2020 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TPE-3012LS / TPE-3018LS
134
4. Click Apply.
5. In the top right, click Save to save the configuration settings to NV-RAM/startup
configuration.
6. Click OK.
Configure ACL Port Binding
ACL > ACL Binding
This section allows users to bind MAC or IPv4 ACLs to specific switch ports or link
aggregation groups.
1. Log into your switch management page (see “Access your switch management page”
on page 11).
2. Click on ACL and click on ACL Binding.
3. Review the settings below.
Item
Description
Port
Display port entry ID.
MAC ACL
Select mac ACL name from list to bind.
IPv4 ACL
Select IPv4 ACL name from list to bind.
IPv6 ACL
Select IPv6 ACL name from list to bind.