Standard Mode Web Interface
Status
View your switch system information
Status > System Information
You may want to check the general system information of your switch such as firmware
version, boot loader information, system time/date, MAC address, system uptime,
administration information, IPv4 information. This section explains how to assign a
name, location, and contact information for the switch. This information helps in
identifying each specific switch among other switches in the same local area network.
Entering this information is optional.
1. Log into your switch management page (see “Access your switch management page”
on page 11).
2. Click on Status and click on System Information.
System Information
• Model – Displays the model name of the switch.
• System Name – Displays the currently assigned system name.
• System Location – Displays the currently assigned system location.
• System Contact – Displays the currently assigned system contact.
Note: Clicking Edit at the top will allow you to modify the System Name, Location,
and Contact information.
• MAC Address: Displays the switch system MAC address.
• IPv4 Address – Displays the current IPv4 address assigned to your switch.
• System Uptime – The duration your switch has been running continuously.
without a restart/power cycle (hard or soft reboot) or reset.
• Current Time – Displays the current system time and date settings of the switch.
• Loader Version – The current boot loader version your switch is running.
• Loader Date – The current boot loader version date your switch is running.
• Firmware Version - The current software or firmware version your switch is
running.
• Firmware Date – The current software or firmware version date your switch is
running.
To Next Page
Loading...
Need help?
General