11. At the end of each command, press ENTER to execute the command. For a successful
execution, the following combinations of Carriage Return <CR> and Line Feed <LF> are
accepted:<CR><LF><CR><LF>Communication baud rate can be configured from 300
baud to 115200 baud.
More Information
‣
Configuration Parameter Descriptions (page 187)
5.2 Entering and Exiting Configuration
Mode
With the OPEN and CLOSE commands you can toggle between configuration mode and
measurement mode. In the measurement mode, OPEN changes the mode to the
configuration mode, and in the configuration mode, CLOSE changes the mode to the
measurement mode. Note that the
configuration mode does not recognize the OPEN
command and the measurement mode does not recognize the CLOSE command.
5.2.1
OPEN — Entering Configuration Mode
To switch WMT700 from the measurement mode to the configuration mode, use the OPEN
command.
$0OPEN<enter>
$
Fixed $ character starts the command.
0 Sensor address. All sensors answer 0 address.
OPEN The OPEN command
<enter> To activate the command, press ENTER.
After a successful OPEN command the sensor switches from measurement mode to
configuration mode and the following symbol is displayed:
>
If the port protocol is SDI-12, ("
s comX_protocol,1"), use the command
0OPEN<ENTER> without the $ character.
WMT700 User Guide M211095EN-H
100
To Next Page
Loading...
