Appendix A. Command Set for
WMT700
The following table lists all the commands available for WMT700.
Table 70 Command Set for WMT700
Configuration Mode / Measurement
Mode and Profile
Command Description
Configuration mode
?
Displays a list of configuration commands.
Configuration mode
BAUD
Changes or displays serial port settings.
Configuration mode
CLEARERR
Resets error counters.
Configuration mode
CLOSE
Switches the serial port to measurement mode.
Configuration mode
ERRORS
Displays error codes and counts.
Configuration mode
G
Displays either all or specified parameters.
Configuration mode
H
Displays list of data messages and available values
for measurement unit, profile, baud rate, interface,
and analog output mode.
Configuration mode
MEAS
Starts wind measurement based on the user-
configurable averaging time. WMT700 does not
send data messages automatically.
Configuration mode
POLL
Tests data polling.
Configuration mode
RESET
Resets WMT700.
Configuration mode
S
Changes selected parameters or defines new data
messages.
Configuration mode
START
Starts continuous measurement.
Configuration mode
STOP
Stops continuous measurement.
Configuration mode
VERSION
Displays the software version.
Configuration mode
WIND_GET
Fetches wind calibration information.
Measurement Mode WMT700 profile
MEAS
Starts wind measurement. The duration of the
measurement is based on the user-configurable
averaging time.
Measurement mode WMT700 profile
OPEN
Switches the serial port to configuration mode.
Measurement mode WMT700 profile
POLL
Fetches data from WMT700.
Measurement mode WMT700 profile
SLEEP
Switches WMT700 from normal operating mode to
low-power mode.
Measurement Mode MES12 profile
@a M 12
Polls data from WMT700 in the MES12 data message
format.
Appendix A – Command Set for WMT700
181
To Next Page
Loading...
Need help?
General
