Vaisala WINDCAP WMT700 Series - WIND_GET - Get Calibration Data; Configuration Parameters; Configurable Data Messages

VERSION
5.7.4 WIND_GET — Get Calibration Data
This command fetches the WMT700 calibration date and other calibration data. This
information is mostly intended for Vaisala technical support.
WIND_GET
5.8 Configuration Parameters
A number of parameters aect WMT700 functionality.
To view and set parameter values, use the G and S commands.
You can
configure WMT700 by sending individual commands or by loading a
configuration file to the sensor.
In the automatic message mode, to initiate continuous measurement, use the START
command.
More Information
‣
Configuration Parameter Descriptions (page 187)
‣
Upgrading from WS425 to WMT700 (page 88)
‣
Loading Settings from
Configuration Files (page 115)
‣
START — Start Continuous Measurement (page 106)
5.9
Configurable Data Messages
You can define new data messages for automatic messaging or polling with the WMT700
profile. Each item in a user-configurable data message string consists of 2 characters after
the \ character. For example, the item for wind speed is \ws. The maximum number of
characters for a string is 80.
The characters are passed to messages as they are. All visible ASCII characters are allowed,
except the available items for data message strings listed in Table 40 (page 110).
Chapter 5 – Operation
109