Vaisala WINDCAP WMT700 Series - 5.6.4 RESET - Reset CPU; 5.7 Information Commands; 5.7.1? - Display Command Set; 5.7.2 H - Display Help and Messages

5.5 Wind Measurement Control
Commands
5.5.1 MEAS — Single Wind Measurement
This command starts wind measurement based on the user-configurable averaging time.
WMT700 does not send the data message automatically. Use the polling command to fetch
measurement data in the required data message format.
MEAS
5.5.2
START — Start Continuous Measurement
This command starts continuous wind measurement. Continuous measurement starts when
you exit the configuration mode or restart WMT700.
You can retrieve data with a polling command or
configure WMT700 to send data messages
at selected intervals. You can set the interval for automatic messages with the autoInt
parameter.
START
5.5.3
STOP — Stop Wind Measurement
This command stops continuous wind measurement.
To restart measurement, use the MEAS or START command. You can fetch the most recent
measurement data at any time with the polling command.
STOP
5.6
Diagnostics and Support Commands
5.6.1 ERRORS — Get Error Codes and Counts
This command fetches error information from WMT700.
ERRORS
The response:
WMT700 User Guide M211095EN-H
106