Vaisala WINDCAP WMT700 Series - 5.20 Entering Configuration Mode; 5.21 F;G ASOS Profile

More Information
‣
Measurement Mode Commands (page 125)
‣
Communicating with Terminal Software (page 99)
‣
Data Messages (page 119)
5.20 Entering Configuration Mode
This command switches the serial port to
configuration mode. The command works with any
communication profile supported by WMT700.
$aOPEN<CR><LF>
$
Fixed text
a
Value of the address parameter. If the value is 0, it refers to any WMT700 address
<CR>
Carriage return
<LF>
Line feed
5.21 F/G ASOS Profile
The following table lists the configurable parameters and their allowed and default values
for the WS425 F/G ASOS
profile.
Table 47
Configurable Parameters for WS425 F/G ASOS Profile
Parameter Default
Value
Profile-Specific Allowed Values Description
autoSend
0 0 = Automatic messages disabled Automatic data message number.
Selects the data message format
for automatic messages
com1_protocol
0
1)
2 = WS425 F/G ASOS Profile for serial port COM1
com2_protocol
2 2 = WS425 F/G ASOS Profile for serial port COM2
com2_interf
N/A
2)
0 = RS-485
1 = RS-422
3 = RS-232
Interface for serial port COM2
wndAvg
5 0.25 … 3600
Resolution: 0.25
Averaging time for wind
measurement in seconds
wndGustTime
3 0.25 … 3600
Resolution: 0.25
Averaging time for wind minimum
and maximum in seconds
Chapter 5 – Operation
135