Figure 29 WMT700 Bird Cage and Bird Cage Straps
1 Bird cage
2 Bird cage straps
3 Wind sensor
4 Guide for attaching the straps
5 Latch for attaching the straps
1. Unpack the bird cage and the straps.
2. Position the bird cage on top of the wind sensor and press the kit down until the three
hooks are in contact with the transducer arms.
3. Run the lower strap through the three guides in the kit.
4. Lift the latch screw, insert the strap to the latch, and press down the latch screw.
5. To tighten the screw, turn it clockwise with a screw driver or a socket. Do not over-
tighten.
6. Run the upper strap through the three guides in the kit, and repeat step 4 and step 5
for it.
4.8.1
Installing Bird Net
In areas with large populations of small birds, you can install a bird net over the bird cage.
1. Cover the bird cage with the bird net.
2. Tighten the bird net with cable ties.
Chapter 4 – Installation
71
To Next Page
Loading...
