S aout1_g,1.00000
S aout1minv,0.00000
S aout1maxv,32000.0
S aout1err,1000.00
S aout1mode,3
S aout2_g,1.00000
S aout2_o,0.00000
S aout2minv,0.00000
S aout2maxv,32000.0
S aout2err,1000.00
S aout2mode,7
S msg1,\ss$\ws,\wd,\se\sp\cr\lf
S msg2,2
S msg3,3
S msg4,4
S address,A
S messages,1
More Information
‣
Configuration Parameter Descriptions (page 187)
5.10 Operating WMT700
When WMT700 is installed and configured, you can start operating the wind sensor:
• To receive wind measurement data through a serial connection as data messages, use
serial communication.
• If you use the WMT700
profile, see the following operating instructions.
• If you use WS425 or SDI-12
profiles, see 5.17 Operating WMT700 with WS425 and
SDI-12 Profiles (page 133)
• To receive wind measurement data as current, potentiometer, voltage, or frequency
output, use analog output.
For a complete list of the serial commands available for the WMT700 series wind sensors,
see A. Command Set for WMT700 (page 181).
More Information
‣
Analog Output (page 43)
‣
Operating WMT700 in WS425 Analog Output Mode (page 128)
Chapter 5 – Operation
117
To Next Page
Loading...
