Vaisala WINDCAP WMT700 Series - Figure 40 FIX30, WS425 FIX60-RST, and WS425 FIX60-POM; Figure 41 Mounting Adapter for FIX30, WS425 FIX60 (Left), and Mounting Adapter for FIX70 (Right)

• Correct mounting kit (already attached to the mast) for a retrofit installation. The
following figure shows the available options: FIX30 and WS425FIX60 mounting kits.
Figure 40 FIX30, WS425FIX60-RST, and WS425FIX60-POM
• Correct mounting adapter for your installation: FIX30, WS425FIX60-POM, or
WS425FIX60-POM. The diameter of the mounting adapter for the adapters is 61 mm.
Change the mounting adapter if necessary. If you are not sure that you have the correct
mounting adapter, contact Vaisala.
Figure 41 Mounting Adapter for FIX30, WS425FIX60 (Left), and Mounting Adapter for
FIX70 (Right)
• Correct cables for the mounting kit and analog output/serial communication. The table
below lists the available cables for a retrofit installation. The In/Out stands for the
possibility to route the cable either inside or outside of the mast.
If you have FIX30, do not use the adapter cables but order the appropriate WMT700
cable. The adapter cable does not
fit inside the mast.
Chapter 4 – Installation
87