Vaisala WINDCAP WMT700 Series - 5.6.2 CLEARERR - Reset Error Codes and Counts; 5.6.3 POLL - Get Message

5.4.3 BAUD — Display or Set Port Settings
This command shows or changes values of the serial port settings.
More Information
‣
Restoring Serial Port Settings (page 170)
5.4.3.1 Set Port Settings
You can use the BAUD command to change the bit rate, parity bit, data bits, stop bit, and
communication profile of the selected serial port.
There is a 100 ms delay after which WMT700 takes the settings into use. Do not send
commands to WMT700 during this time.
BAUD x,y,z,w
x
Bit rate (300, 1200, 2400, 4800, 9600, 19200, 38400, 57600, or 115200)
y Data bits (7 or 8)
z Parity (n = none, e = even, o = odd)
w Stop bits (1 or 2)
Example
The bit rate is set to 115200, data bits to 8, parity to none, and stop bits to 1:
BAUD 115200,8,n,1
5.4.3.2 Display Port Settings
You can use the BAUD command to display the current serial port settings.
BAUD
Chapter 5 – Operation
105