4.4 Connecting WMT700 Cable
When installing WMT700, route the cable according to the mounting option. When
mounting to a mast, you can the route cable either outside or inside the mast. Cable routing
depends on the mast type and other equipment, such as air terminals, installed on the mast.
Make sure that you prepare or connect only de-energized wires.WARNING!
Do not perform installation or maintenance procedures when there is a
risk of thunderstorm or lightning activity in the area.
WARNING!
A long cable between units (sensors, transmitters, power supplies, and
displays) can cause a lethal lightning-induced current surge. Always ground the
enclosure to a suitable grounded location with a short, low-resistance cable.
WARNING!
Make sure that the cable is properly attached to the mast or cross arm
before starting the installation. Otherwise, it may slip and fall down during the
installation procedure.
CAUTION!
To avoid strain on the connector, make sure you connect the cable properly.
Too much strain may cause the cable to fall
o, damage the cable or connector, or make
the cable or connector susceptible to water leakage.
CAUTION!
WMT700 User Guide M211095EN-H
54
To Next Page
Loading...
