Item Description
\ws Wind speed, average
\wx Wind speed average, x component
\wy Wind speed average, y component
Table 41 Control Character
Item Description
\01 SOH (start of heading)
\02 STX (start of text)
\03 ETX (end of text)
\04 EOT (end of transmission)
\cr CR (carriage return)
\lf LF (line feed)
\se Checksum calculation end point
\sp Print checksum
\ss Checksum calculation start point
Table 42 Monitoring Items for Data Messages
Item Description
\er Status code. The code is a decimal number. Each bit corresponds to a status flag. For a
list of the bits, see 5.9.2 Status Flags (page 113)
\fb 0 = No error
1 = Blocked sensor
\fh 0 = No error
1 = Heater failure. Incorrect heater resistance.
\fs 0 = No error
1 = Wind speed exceeds operating limits
2 = Sonic temperature exceeds operating limits
3 = Wind speed and sonic temperature exceed operating limits
\ft This value indicates temperature sensor failures when converted to binary format:
Bit 0 = Temperature sensor 1 failure
Bit 1 = Temperature sensor 2 failure
Bit 2 = Temperature sensor 3 failure
Chapter 5 – Operation
111
To Next Page
Loading...
