Vaisala WINDCAP WMT700 Series - Serial Communication; Communication Interface; Profiles

• Analog output signals for wind speed channel (AOUT1)
• Analog output signals for wind direction channel (AOUT2)
3.7 Serial Communication
In WMT700, there are two serial communication ports:
• COM1: Service port (RS-485)
• COM2:
Configurable digital communication interface
Both ports support the same commands, protocols, operations, and data messages. You can
use any computer or data logger with a serial port to send commands to WMT700 and to
receive measurement data.
3.7.1
Communication Interface
COM1 is a fixed RS-485 communication interface to be used as a service port.
COM2 is a flexible digital communication interface that is preconfigured according to your
order. The available options are:
• RS-232 (recommended up to 15 meter distance)
• RS-485 (recommended up to 1200 meter distance in point-to-point connection)
• RS-422 (recommended up to 1200 meter distance)
• SDI-12 (recommended up to 60 meter distance)
Note that the recommendations depend on communication speed and cable type. In
optimized environments even longer distances can be considered.
Regardless of the factory configuration, you can change the COM2 interface type by using
terminal software.
More Information
‣
Configuration Parameter Descriptions (page 187)
‣
Wiring (page 72)
3.7.2
Profiles
The digital communication profile is used to preconfigure WMT700 according to your order
at the factory. Depending on the
preconfigured communication profile, the default settings
of the following parameters can be:
• Communication protocols
• Communication parameters
The preconfigured communication profiles are:
• WMT700
• ROSA - MES12
• WS425 - ASCII
• WS425 - NMEA Extended (version 0183)
• WS425 - SDI-12 (version 1.3)
WMT700 User Guide M211095EN-H
40