Vaisala WINDCAP WMT700 Series User Manual

$
Fixed text
a
WMT700 address. If the value is 0, it refers to any WMT700 address.
More Information
‣
Configuration Parameters (page 109)
5.11.2 ROSA - MES12 Profile Commands
When the ROSA - MES12 profile is selected, you can poll data in the MES12 data message
format. This data message is used in the ROSA Surface Analyzer for Roads and Runways
system. You can use this data message when WMT700 is connected to the Vaisala ROSA
system.
5.11.2.1 M 12 — Poll MES12 Data Message
This command fetches data from WMT700 in the MES12 data message format.
@a M 12<CR><LF>
@
Fixed text
a WMT700 address. The allowed range is from 0 to 99.
More Information
‣
ROSA - MES12 Data Message (page 124)
5.12
Operating WMT700 in WS425
Analog Output Mode
5.12.1 Analog Output Settings
In analog output operation WMT700 takes measurements according to the configured
averaging time and synthesizes the analog outputs of wind speed and wind direction with
an update interval of 0.25 seconds. The analog output signal type and range depend on the
configured settings.
Normally, analog output is enabled and the output settings are preconfigured at the factory
according to your order. WMT700 can be operated using these settings directly after the
installation. However, the analog output settings of WMT700 can be changed or the analog
output functionality can be disabled at any time to save power over the serial interface.
When operating WMT700 in a system
configured for WS425, you must configure the analog
output settings according to the following table using the S command.
WMT700 User Guide M211095EN-H
128

Vaisala WINDCAP WMT700 Series Specifications

General

Brand	Vaisala
Model	WINDCAP WMT700 Series
Category	Accessories
Language	English