TITANUS
MICRO·SENS
®
Installation
06/13
101
Installation
General
The regulations, guidelines and instructions given in chapter "Design" are
valid.
When installing the TITANUS
MICRO·SENS
®
air sampling system, the fol-
lowing must be taken into consideration:
1. there should be no changes made to the equipment. Where this is un-
avoidable the operator, manufacturer and/or supplier must be in-formed
(written approval).
2. any changes in the supply network (230 V/400 V supply) and external
supply systems must be carried out by the system owner. This includes
e.g.:
– the primary connection of the supply units
– any connections to external systems (e.g. central units)
– planning of possible additional lightning protection and voltage surge
protection, which conform to standards
6
6.1
To Next Page
Loading...
