Service Manual FB 7100 Programming
January, 2005 4- 43
Setting energy
saving periods
• Seven energy saving periods can be programmed on a weekly basis:
the week days are identified by progressive numbers:
(0=Monday, 1=Tuesday, etc.) and all weekdays (ALL=7).
• The same time period cannot include days from different weeks, i.e. a
period cannot be set from Monday to Monday.
• A period cannot have a ‘start time’ later than the ‘end time’, see Non
Example 2.
• If the periods are set overlapping, the energy saving will be active for
as long as it is covered by one of these periods, cf. Example: Period 3.
• Two energy savings in a period require two period settings, cf.
Example: Period 1 and 2.
• Non Examples 1 and 2 describe settings which will give unintended
results.
Set day(s) Up to seven automatic rinse periods can be set in
the machine.
In this menu days are defined:
The setting of day(s) is carried out in two steps:
1. Select a period (1-7).
2. Set the start day and end day for the selected
period.
0 = Monday
1 = Tuesday
etc.
7 = All (every day of the week).
Set time In this menu time (hours and minutes) for each
period is defined.
The setting of time is carried out in two steps:
1. Select a period (1-7).
2. Set the start time and end time for the selected
period.
The time is set in 24-hour format.
Set temperature In this menu the required low temperature is set,
e.g 65° C.
The water temperature will lower to this
temperature during the defined periods.
Set doorlight If this option is set to “On”, the light in the machine
door will be turned off during the energy saving
periods.
If the option is set to “Off”, the light will stay on
during the energy saving periods.
Sub menu Description
To Next Page
Loading...
