Xerox 8830 - Page 153

Replacement
1. Reinstall the Toner Cartridge Home Sensor.
2. Perform the Toner Cartridge Home Sensor
Adjustment (ADJ 9.5).
1
Reinstall the
Cartridge Drive
Plate with the sea]
up
CAUTION
To avoid damage to the Drive Plate Seal, always
rotate the drive plate in the direction shown in
Figure 3.
3. (Figure 2): Reinstall the Cartridge Drive Plate.
Reinstall the
screws (2) and the
Ground wire
(Figure 3): Reinstall the Top Shield, taking care
not to overtighten the screws.
Connect Ml
Tighten (he
screws (2)
Reinstall the
screws (2)
Reinstall the Top
Shield
Figure 3. Reinstalling the Top Shield
5. Reinstall the Developer Module (REP 9.5).
R1799
Figure 2. Reinstalling the Cartridge Drive Plate
1/98
4-69
REP 9.12
4
3
2
1