NOTE; Insert the Extractor Tab until the face
of the tool is flush with the connector housing.
3. (Figure 3):Remove the terminal from the
connector.
Insert the long Extractor
Tab through the window
in the housing
Long Extractor Tab (working edge of tool)
Terminal Removal through the housing
Remove the terminal
from the housing
(Terminal shown rotated
90 degrees)
Short Extractor Tab (working edge of tool)
Insert the short Extractor
Tab through the window in
the Module Connector
Terminal Removal with the Module Connector already removed from the housing
Remove the terminal
(Terminal shown rotated
90 degrees)
01896B
Figure 3. Removing the Terminal from the Connector
8830
1/98
6-35
Molex Connector Repair Procedure
To Next Page
Loading...
