Starting the Diagnostic Software from a Floppy Disk
1. Ensure that the computer is running Microsoft Windows 3.1, 3.1.1, or Windows 95. MS-
DOS 6.2 or better must also be present. The diagnostic software will only operate under
one of these operating systems.
2. Close the Windows program manager.
3. Switch off the computer and the scanner.
4. Connect the SCSI cable from the scanner to the SCSI port of the computer on which the
diagnostics will also be run.
5. Switch on the scanner.
6. Switch on the computer, allow it to boot, and then type WIN to start Windows.
7. Insert the SCSI7356 floppy disk into the floppy disk drive of the computer.
8. Open the Program Manager in Windows, and choose RUN from the File menu.
9. Type A:SCSI7356 and press the ENTER key.
• The software starts. Enter the password and press the START key on the keyboard.
Then select the START button. Refer to Using the Diagnostic Software for further
Instructions.
3/96 General Procedures
8830 DDS
6-15 Diagnostics
To Next Page
Loading...
Need help?
General
