Xerox 8830 Service Manual

Call Back
1. Follow the Call flow Diagram and resolve the problem that caused
the Call Back.
2. Perform the Final Action. Do Not perform the Maintenance
Procedures.
Final Action
1. Make one D (A1) size copy on 20 Ib (80 gsm) bond paper of Test
Pattern 82E5980.
a. Evaluate the copy and ensure that the copy meets the image
Quality Specifications in Section 3.
b. If the copy is not within the specification, refer to the Entry Copy
Quality (CQ) RAP and follow the procedure to eliminate any
defects.
c. Evaluate the copy for any visible defects.
d. If the copy exhibits any visible defects, refer to the appropriate
Copy Quality (CQ) RAP and follow the procedure to eliminate
the defects.
2. Make a copy.
3. Check that the copy count meters on the Image Output Terminal
(IOT) have advanced.
4. Fill out the Service Call Report. Record all activities in the service
log.
5. If new developer material was installed in the IOT, write the
developer batch number in the Service Log.
6. Give appropriate copy credits to the customer.
7. If service was performed on the IOT or the Scanner, use the serial
numbers of the IOT or the Scanner to close the call. Report both the
IOT meters A and B when closing the call.
Call Back/ Final Action
4/97
1-8
7356 Scanner

Xerox 8830 Specifications

General

Brand	Xerox
Model	8830
Category	Printer
Language	English