Xerox 8830 - Page 556

4. Lower the right end of the roll into place, and align the Right Bearing
with the hole in the Frame.
5. (Figure 5): Seat the Right Bearing:
Hold the Bushing over the
Left Bearing
B
Guide the Bushing through the
hole in the left side of the Frame,
while seating the Right Bearing on
the right side of the Frame
Bearing correctly
seated
Right Bearing
incorrectly
seated
6. (Figure 3): Install the Bushing Retaining Clip.
7. (Figure 2): Install the Main Drive Belt.
8. Position the Motor Assembly to tighten the Main Drive Belt; then
tighten the two screws that secure the assembly.
9. Connect the Lamp Socket to the Exposure Lamp.
10. (Figure 1): Install the Document Hold-down Guide.
11. Install the Left Side Panel (REP 4.1.1).
12. Perform the following adjustments:
• Calibrate Motor Speed (ADJ 4.1.1)
• Calibrate Document Registration (ADJ 4.1.2)
Figure 6. Seating the Right Bearing
REP 4.1.17
4/97
4-32 7356 SCANNER