11. Install the floppy disk containing the scanner diagnostic software into
the A: floppy disk drive.
12. If the Windows operating program is not already started on the host
computer after the boot process, then start Windows, by typing WIN
and pressing the <enter> key.
13. Type a: SCSI7356 and press the <enter> key.
• The diagnostic software starts. Refer to Using the Diagnostic
Software, located in this section, for information about the
operation of this software. The password is ES8150.
14. Do the Front-to-Back Stitch adjustment (ADJ 4.1.3)
15. Do the Left to Right Stitch adjustment (ADJ 4.1.4)
16. Exit the diagnostic software.
17. Remove the disk from the A: drive.
18. Install the Scanner application software on the customer's host
computer:
a. Ensure that Windows is running.
b. Terminate any other applications that are currently running.
c. Insert disk 1 into the A: floppy disk drive.
d. Type A S SETUP and press the <enter> key.
e. Follow the instructions on the screen.
19. Make a test scan of the 082E11490 test pattern and view the image.
20. Examine the image for correct image quality:
• The horizontal and diagonal lines have no objectionable
discontinuity due to stitch error
• There are no deletions or distortions of the image.
12/97
7356 Scanner 6-29 . Scanner Installation
To Next Page
Loading...
Need help?
General
