February 2013
6-24
ColorQube® 9303 Family
GP 7
General Procedures/Information
Figure 2 shaft ground spring
Transfix
• Figure 3, transfix blade. Check for continuity of less than 10 Ohms between the blade
frame and the machine base. To improve continuity, remove and clean or install a new
transfix stripper assembly, PL 10.20 Item 14 as necessary.
Figure 3 Transfix blade
• Figure 4, transfix roller. Check for continuity of less than 10 Ohms between the inner roller
core and the machine base and 10 Ohms between the outer roller and the machine base.
To improve continuity, disconnect the ground strap, clean the contact faces and re-assem
-
ble.
1
Remove screw then the
contact spring.
Stripper baffle hinge shaft
Transfix blade
To Next Page
Loading...
