5.3 Multiturn Limit
5.3.3 Programming Example
5-50
* The value set in DW00006 is determined as given in the following table.
* Example: When High-speed Scan Setting = 1 ms and MECHATROLINK-III Transmission Cycle Setting = 250 μs
Software timer default value = 1
When High-speed Scan Setting = 0.5 ms and MECHATROLINK-III Transmission Cycle Setting = 1 ms
Software timer default value = (1 ms / 0.5 ms − 1) × 4 + 1 = 5
Condition Setting
High-speed scan setting ≥ MECHA-
TROLINK-III transmission cycle setting
1
High-speed scan setting < MECHA-
TROLINK-III transmission cycle setting
(MECHATROLINK-III transmission cycle setting/High-speed
scan setting - 1)
× 4 + 1
Software timer default value*
To Next Page
Loading...
