YASKAWA SVC - 7.2 MECHATROLINK Communications Settings

7.2 MECHATROLINK Communications Settings
7.2.1 Displaying the MECHATROLINK Detail Definition Dialog Box
7-7
7
Making Settings for Motion Control with the MPE720
7.2 MECHATROLINK Communications Settings
To perform motion control using the SVC Function Module, you must first make settings for
MECHATROLINK communications.
Use the MECHATROLINK Detail Definition Dialog Box to make settings for MECHATROLINK
communications.
The section describes how to open the MECHATROLINK Detail Definition Dialog Box, its con-
tents, and how to use it to make settings.
7.2.1 Displaying the MECHATROLINK Detail Definition Dialog
Box
Use the following procedure to display the MECHATROLINK Detail Definition Dialog Box.
Double-click the SVC32 cell in the Module Configuration Definition Tab Page.
The MECHATROLINK Communications Definition Dialog Box is displayed.
If more than one Module is mounted, select the Module to be checked or set.
Information