YASKAWA SVC - Operating Procedure

6.5 Waiting for Slave Detection with the SVC Function Module
6.5.3 Operating Procedure
6-15
6
Other Useful Functions
6.5.3 Operating Procedure
Use the following procedure to enable waiting for slave detection.
1. Start the MPE720 on a computer that is connected to the MP3000.
2. In the Main Window of the MPE720, click Setup − Module configuration from the
Launcher, or Module Configuration from the Start Menu.
The Module Configuration Definition Tab Page will be displayed.
3. Double-click the SVC4 cell in the Module Configuration Definition Tab Page.
The MECHATROLINK Detail Definition Dialog Box will be displayed.
4. Click the Transmission Parameters Tab .
The Transmission Parameters Tab Page will be displayed.