YASKAWA SVC - 10.2.2 Inverter Settings

10.2 Setup Procedure
10.2.2 Inverter Settings
10-4
10.2.2 Inverter Settings
Use the following flowchart to make the Inverter settings.
The procedures for STEP 1 to STEP 5 are given below.
STEP 1: Define the Module Configuration of the Inverter
You can define the Module configuration of the Inverter either automatically or manually.
 Automatic Definition Method
1. Execute self configuration on the MP3000.
When you execute self configuration, information on the Modules that are connected to the MP3000
is detected and the Inverter I/O registers are assigned in the SVC definition file. Refer to the following
manual for the procedure to execute self configuration.
MP3000 Series Machine Controller Setup Manual (Manual No.: SIEP C880725 00)
2. Open the Module Configuration Tab Page. Refer to step 2 in  Manual Definition
Method for the procedure.
3. Confirm that communications have been established. Refer to steps 8 to 12 in the 
Manual Definition Method for the procedure.
This concludes the procedure.
 Manual Definition Method
1. Start the MPE720 on a computer that is connected to the MP3000.
2. In the Main Window of the MPE720, click Setup - Module configuration from the
Launcher, or the Module Configuration Icon on the My Tool View of the Start Tab Page.
The Module Configuration Definition Tab Page will be displayed.
STEP 1: Define the Module Configuration of the Inverter
↓
STEP 2: Set the Required Fixed Parameters
↓
STEP 3: Confirm That the Inverter Is Ready for Operation
↓
STEP 4: Execute the Inverter Operation Control Command
↓
STEP 5: Set the Required Setting Parameters