2.3 System Configuration Example
2-13
2
Basic Information on Motion Control Function Modules
Using the MP3300
The following figure shows a system configuration example that uses the SVC.
* This manual primarily describes this area.
Note: 1. Refer to the following manual for information on cables, connectors, and applicable SERVOPACKs.
MP3000 Series MP3300 Product Manual (Manual No.: SIEP C880725 21)
2. When you connect a SERVOPACK through MECHATROLINK communications, connect the wiring for input
signals, such as overtravel, the zero point return deceleration limit switch, and external latches, to the SER-
VOPACK. Refer to the relevant SERVOPACK manual for details on the connections.
Turn ON the power supply to the MECHATROLINK-III slave devices first or at the same time as
the MP3000. If turning ON the power supply to the MP3000 first is unavoidable, reset the net-
work after you turn ON the power supply to the MECHATROLINK slave devices.
Otherwise, MECHATROLINK communications may not be performed correctly.
Turn ON the power supply to the MECHATROLINK-III slave devices first or at the same time as
the MP3000. If turning ON the power supply to the MP3000 first is unavoidable, reset the net-
work after you turn ON the power supply to the MECHATROLINK slave devices.
Otherwise, MECHATROLINK communications may not be performed correctly.
PC
Ethernet communications cable
Host PLC
Battery
MP3300
RLYOUT
connector cable
Front cover for
unused slot
MPE720 Integrated
Engineering
Tool Version 7
24-VDC power supply,
AC power supply, or
status monitoring device
Power cable
24-VDC power supply
or AC power supply
*
HUB
Up to 21 stations, including I/O (Up to 16 stations can be Servos.)
I/O
Servomotor
MECHATROLINK-III Cable
SERVOPACK with MECHATROLINK-III
Communications References
MECHATROLINK-III
I/O Module with
MECHATROLINK-III
Communications
Servomotor Servomotor
To Next Page
Loading...
