YASKAWA SVC - Stepping Motor Drive Operation

ix
 Storage Precautions
 Transportation Precautions
NOTICE
 Do not attempt to use a SERVOPACK or Servomotor that is damaged or that has missing parts.
 Install external emergency stop circuits that shut OFF the power supply and stop operation
immediately when an error occurs.
 In locations with poor power supply conditions, install the necessary protective devices (such as
AC reactors) to ensure that the input power is supplied within the specified voltage range.
There is a risk of damage to the SERVOPACK.
 Use a Noise Filter to minimize the effects of electromagnetic interference.
Electronic devices used near the SERVOPACK may be affected by electromagnetic interference.
 Always use a Servomotor and SERVOPACK in one of the specified combinations.
 Do not touch a SERVOPACK or Servomotor with wet hands.
There is a risk of SERVOPACK failure.
CAUTION
 Do not place an excessive load on the SERVOPACK during storage. (Follow all instructions on
the packages.)
There is a risk of injury or damage.
NOTICE
 Do not install or store the SERVOPACK in any of the following locations.
• Locations that are subject to direct sunlight
• Locations that are subject to ambient temperatures that exceed SERVOPACK specifications
• Locations that are subject to relative humidities that exceed SERVOPACK specifications
• Locations that are subject to condensation as the result of extreme changes in temperature
• Locations that are subject to corrosive or flammable gases
• Locations that are near flammable materials
• Locations that are subject to dust, salts, or iron powder
• Locations that are subject to water, oil, or chemicals
• Locations that are subject to vibration or shock that exceeds SERVOPACK specifications
• Locations near devices that generate strong magnetic fields
• Locations that are subject to radiation
If you store or install the SERVOPACK in any of the above locations, the SERVOPACK may fail or be
damaged.
CAUTION
 Transport the SERVOPACK in a way that is suitable to the mass of the SERVOPACK.
 Do not use the eyebolts on a SERVOPACK or Servomotor to move the machine.
There is a risk of damage or injury.
 When you handle a SERVOPACK or Servomotor, be careful of sharp parts, such as the corners.
Doing so may result in injury.
 Do not place an excessive load on the SERVOPACK during transportation. (Follow all instruc-
tions on the packages.)
There is a risk of injury or damage.