Yealink T5 Series

Call Features
219
Example:
account.1.dialplan.digitmap.interdigit_short_timer = 4|5|3|6|2|1
If “dialplan.digitmap.string” is set to <[2-9]x:86>3.T|2T|1xxT|0x.!|[2-9]11T, 4 is applied to the “<[2-
9]x:86>3.T” digit map, 5 is applied to “2T” digit map, 3 is applied to “1xxT” digit map, 6 is applied to “0x.!”
digit map, 2 is applied to the “[2-9]11T” digit map, the last digit 1 is ignored.
Default 3
Parameter
account.X.dialplan.digitmap.no_match_action
[1]
<MAC>.cfg
Description
It configures the behavior when an impossible digit map match occurs.
Note: It works only if “account.X.dialplan.digitmap.enable” is set to 1 (Enabled). The value configured by
the parameter “account.X.dialplan.digitmap.no_match_action” takes precedence over that configured by
the parameter “dialplan.digitmap.no_match_action”.
Permitted
Values
0-prevent users from entering a number and immediately dial out the entered numbers
1-the dialing will fail and the phone screen will prompt “Forbidden Number”
2-allow users to accumulate digits and dispatch call manually with the send key or automatically dial out
the entered number after a certain period of time configured by the parameter “dial-
plan.digitmap.interdigit_long_timer”
Default Blank
Parameter
account.X.dialplan.digitmap.active.on_hook_dialing
[1]
<MAC>.cfg
Description
It enables or disables the entered numbers to match the predefined string of the digit map in real time on
the pre-dialing screen.
To enter the pre-dialing screen, directly enter numbers when the phone is idle.
Note: It works only if “account.X.dialplan.digitmap.enable” is set to 1 (Enabled). The value configured by
the parameter “account.X.dialplan.digitmap.active.on_hook_dialing” takes precedence over that con-
figured by the parameter “dialplan.digitmap.active.on_hook_dialing”. It is not applicable to CP960
phones.
Permitted
Values
0-Disabled
1-Enabled
Default Blank
Parameter
account.X.dialplan.digitmap.apply_to.on_hook_dial
[1]
<MAC>.cfg
Description
It enables or disables the entered number to match the predefined string of the digit map after pressing a
send key on the pre-dialing screen or pressing the DSS key (for example, speed dial, BLF or prefix DSS
key).
To enter the pre-dialing screen, directly enter numbers when the phone is idle.
Note: It works only if “account.X.dialplan.digitmap.enable” is set to 1 (Enabled). The value configured by
the parameter “account.X.dialplan.digitmap.apply_to.on_hook_dial” takes precedence over that con-
figured by the parameter “dialplan.digitmap.apply_to.on_hook_dial”.
Permitted
Values
0-Disabled
1-Enabled
Default Blank
Parameter
account.X.dialplan.digitmap.apply_to.directory_dial
[1]
<MAC>.cfg