Chapter 3 PERFORMING MEASUREMENTS
3-27
3. Locate the cursor to “4” by using [W] / [X].
4. Change to “5” by using the rotary knob or [S].
5. Locate the cursor to “8” by using [W] / [X].
6. Change to “0” by using the rotary knob or [T].
7. Press [ENTER] to register the change made to the group index.
8. Press [F4] (DONE) to register the changes made to the measurement
conditions.
When changing the condition for two or more items, it is recommended to change
the condition for each item first and then press [F4].
Refer to the notes given on changing the measurement conditions (page 3-50).
TIP
Refer
To Next Page
Loading...
Need help?
General
