Chapter 3 PERFORMING MEASUREMENTS
3-95
•To recall a file saved using AQ7931 emulation software (Ver.2.8 or later), make
sure that the data is saved in .TRD or SOR (Bellcore) format.
•The trace data of measured by 60k in data size or 640km in distance range cannot
be saved in TRD format.
•Even if data has been saved in SOR (Bellcore) format, it cannot be recalled using
AQ7931 emulation software (Ver.2.8) if its data size exceeds 20,000.
For the AQ7932 Emulation Software supporting all the file formats and conditions,
contact the dealer from which you purchased the instrument.
3. Locate the cursor to “.SOR(Telcordia)” by using the rotary knob or [S] / [T].
4. Press [ENTER] to register the change made to the file type.
Caution
TIP
To Next Page
Loading...
