YOKOGAWA PX8000

2-13
IM PX8000-02EN
AUX Settings (Aux Settings)
Press the Aux Settings soft key to display the following screen.
When the input signal type is Analog When the input signal type is Pulse
• When the linear scaling mode is AX+B • When the linear scaling mode is AX+B
• When the linear scaling mode is P1-P2 • When the linear scaling mode is P1-P2
Set the scaling coefficient.
Set the offset.
Set the unit string.
Select the display mode.
Select the unit prefix.
Select the decimal place.
Set the linear scaling mode to AX+B.
Set the input signal type to Analog.
Set the input signal type to Pulse.
Set the linear scaling mode P1-P2.
Set the input signal type to Analog. Set the input signal type to Pulse.
Measured
values
Scale values
Retrieve the current
measured values
Scale value
Same feature as when
linear scaling mode is
set to AX+B
Measured
values
2.4 Configuring Sensor Input Voltage Measurements