24-7
IM PX8000-02EN
24.7 Configuring the Environment Settings
This section explains the following environment settings.
• Action to perform at power on
• Terminal (external I/O terminal) signal
• Display settings
Font size, menu background color, scale value display, numeric display frame, number of digits to
display for numeric data, intensity
• Key and knob control settings
Turning the click sound on and off, start and stop response time, key lock type and release type
• Frequency display when the measured frequency is less than the lower limit
• AUX display when the measured pulse frequency is less than the lower limit
• Analysis settings
Cursor read mode
► Features Guide: “Environment Settings (Preference)”
UTILITY Preference menu
Press UTILITY and then the Preference soft key to display the following menu.
Set the frequency value that is displayed when the measured frequency is less
than the lower limit (Zero, Error).
Set the AUX value that is displayed when the measured pulse frequency is less
than the lower limit (Zero, Error).
Analysis settings
Configure the display settings.
Configure key and knob control settings.
Configure the action to perform at power on.
Set the terminal (external I/O terminal) signal.
Setting the Action to Perform at Power On (Power On Action)
Press the Power On Action soft key to display the following screen.
Sets whether to start waveform acquisition at power on (ON/OFF).
Sets the action mode at power on to the setting that was used when
the power was turned off (ON) or sets the action mode to off (OFF)
To Next Page
Loading...
Need help?
General
