3-15
IM PX8000-02EN
3.13 Triggering on a Pulse Width Trigger (Enhanced)
This section explains the following settings for triggering on a pulse width trigger.
• Trigger source
• State condition
• Determination mode
• Reference time
• Trigger condition
► Features Guide: “Pulse Width Trigger (Enhanced)”
ENHANCED Pulse Width Trigger Menu
Press SIMPLE/ENHANCED and then the Setting soft key to select Enhanced. The following menu
appears.
Set Setting to Enhanced.
Set the trigger hold off. ► section 3.3
Set the trigger type to Pulse Width.
Set the state and trigger conditions.
Setting the State and Trigger Conditions (Set Pattern)
Press the Set Pattern soft key to display the following menu.
Set the state condition (H, L, or X (do not use as a trigger source)).
Set the trigger level.
* Set T1 and T2 when the determination mode is B Between.
Set Time when the determination mode is B < Time, B >Time, or B TimeOut.
Set the determination mode.
Set the reference time.*
Set the hysteresis ( , , ).
To Next Page
Loading...
Need help?
General
