Zebra ZXP Series 3 - Appendix B Magnetic Encoder Option

5: Replacement Procedures
Removal Sequence
P1061317-002 Zebra ZXP Series 3 Card Printer Service Manual 101
5.3 Removal Sequence
The figures on this page and the following page show the recommended sequence for
removing parts.
For each item, follow the diagram upward to see what must be removed for access. For
example, to remove the Smart Card Module, you would remove the Left Side Cover, Right
Side Cover, and Front Bezel; follow the red path below.
5.5.3
Left Side Cover
page 114
5.5.5
Top Cover
page 116
5.5.4
Right Side Cover
page 115
5.5.9
Printhead Fan
page 123
5.5.8
LCDisplay
page 122
5.5.10
Feed Cover
Sensor
page 124
5.5.1
Printhead
Assembly
page 105
5.5.2
Ribbon
Sensor
page 113
5.5.21
Front Bezel
page 142
5.5.22
Smart Card
Module
page 143
5.5.23
Smart Card
Sensor
page 144
5.5.24
Smart Card
Pulley and Belt
page 145
5.5.7
Lock
page 119
5.5.12
Feeder Cover
page 126
5.5.41
Cleaning Roller
page 182
5.5.11
Feeder Latch
page 125