26 Zebra ZXP Series 3 Card Printer Service Manual P1061317-002
2: Installation and Setup
Installing the Windows Printer Driver
2.7.2 Ethernet Driver Installation
Step 1. If not already done, connect power to the printer. Turn power ON.
Step 2. Connect the Ethernet port on the rear of the printer to the Ethernet network
connection or directly to the computer’s Ethernet port.
Step 3. Ensure that the Printer’s power switch in the ON ( | ) position.
Step 4. Insert the User Documentation and Drivers CD into the CD drive of the host
computer. The Main Menu will open.
Step 5. From the Main Menu, click Install Printer Driver.
Step 6. The InstallShield Wizard window will open. To proceed with the installation, click
the Next button.
Note • To install the USB driver, see USB Driver Installation on page 21.
Important • The Ethernet Network must be configured correctly, with the Printer and the
host computer on the same subnet mask. If you are not sure how to verify this or change the
configuration, consult someone knowledgeable on Ethernet Networks.
To Next Page
Loading...
