Zebra ZXP Series 3 - Contact Station

5: Replacement Procedures
Procedures
P1061317-002 Zebra ZXP Series 3 Card Printer Service Manual 109
Tests and Adjustments
Step 1. Ensure that a YMCKO Ribbon is installed in the printer.
Step 2. Go to Start > Settings > Printers and Faxes. Right click on the Zebra ZXP Card
Printer listing, and select Printing preferences.
Step 3. The Printer Preferences window will open.
Step 4. Select the Card Setup tab.
Step 5. Set Monochrome Conversion to Barcode.
Step 6. Set Ribbon Combination to Front YMCO, Back K.
Step 7. Click the Image Control button.
Step 8. Observe the Image Control window.
Step 9. Set the Black slider to 0.
Step 10. Click the Close button to close the Image Control window.
Step 11. Click the OK button to save the settings, and close the Printing Preferences window.
Important • Driver Version 2.02.00.00 or higher and Firmware Version 1.04.00 or higher
must be installed in your printer.
Step 5
Step 6
Step 7