Zebra ZXP Series 3 - Enter the half-panel command

5: Replacement Procedures
Procedures
P1061317-002 Zebra ZXP Series 3 Card Printer Service Manual 115
5.5.4 Right Side Cover
Step 1. Locate the two screws (circled below) that hold the Right Side Cover in place.
Step 2. With a TORX T10 driver, loosen the two screws (9.0 in-lb).
Step 3. Remove the Right Side Cover.
NOTE • This procedure uses Spare Kit # P1031925-243: KIT, SIDE PANELS BEZELS.