Zebra ZXP Series 3 - 5.5.38 Mag Encoder Assembly - Head and Sensor

178 Zebra ZXP Series 3 Card Printer Service Manual P1061317-002
5: Replacement Procedures
Procedures
5.5.38 Mag Encoder Assembly - Head and Sensor
Step 1. Locate the Mag Encoder Assembly (circled below).
Step 2. With a TORX T10 driver, remove the two screws (SCR, PLAST, 4-.37L, 4.0 in-lb)
holding the Mag Encoder Assembly in place.
NOTE • This procedure uses Spare Kit # P1031925-011: KIT, MAGHEAD REPLACEMENT
or Spare Kit # P1031925-013:
KIT, MAG HEAD W/SENSOR.