Zebra ZXP Series 3 - Replacement

170 Zebra ZXP Series 3 Card Printer Service Manual P1061317-002
5: Replacement Procedures
Procedures
Replacement
Replacement is performed by reversing the removal steps. Note the special instructions on the
following pages when reinstalling the gears and belts.
Note the following when re-installing the Printhead Lift Cam
Step 1. Apply Super Lube Synthetic Multi-Purpose Grease, Zebra P/N 807048-001, to the
two surfaces (arrows below) all the way around.
.
Step 2. Apply Super Lube Synthetic Multi-Purpose Grease to the surface (arrow below) all
the way around.
.