Zebra ZXP Series 3 - Appendix D Half-Panel Ribbon Operation

5: Replacement Procedures
Procedures
P1061317-002 Zebra ZXP Series 3 Card Printer Service Manual 111
Step 15. This brings up the Tools display.
Step 16. In the Command Line (left arrow above), type the Printhead Resistance
command (!R), a space, and the resistance (e.g., 1234) of the replacement
Printhead. For this example, the complete command is !R 1234.
Step 17. Click the Execute button.
Step 18. <ACK> should appear in the Printer Status field indicating that the Printhead
Resistance command was successfully completed.
Step 19. In the Command Line, type the Calibration command (!SAP), a space, and 3 (for
the ribbon color detect sensor). The complete command is !SAP 3.
Step 20. Click the Execute button, and wait while the ribbon motor runs for approximately
25 seconds.
Step 21. A string of values followed by <ACK> should appear in the Printer Status field
indicating that the Calibration command was successfully completed.
Step 22. This completes the ribbon color detect sensor calibration.
Type the
command
here ...
... then
click the
Execute
button.
Important • Ensure that a YMCKO Ribbon is installed in the printer.